Synthesis and Characterization of Amorphous TiO2 Anode Prepared by Anodizing Method for Na-ion Batteries

Dwi Indrawati, Nirwan Syarif, Dedi Rohendi

Abstract


Sodium ion battery (SIB) has engage sustainable alternative on replacing lithium ion batteries. The lower potential and larger ionic value has demanded on seeking a potential anode materials. Amorphous TiO2 prepared by electrochemical anodisation technique has provide a suitablility as anode SIB materials, which approved by conducting XRD, FTIR, and SEM-EDX measurements. Electrochemical performance was tested with variations in the concentration of NaOCl4 electrolyte in propylene carbonate (PC) solvent. Diffractogram of TiO2 showed the only peaks of Ti was observed at 2θ = 40.34. The TiO2 IR spectrogram shows that the absorption band at 507 cm-1 is the peak of the vibration characteristics of the Ti-O bond and the peak of 975 cm-1 corresponds to Ti-O-Ti bond. SEM-EDX image analysis showed the morphology of TiO2 was smooth without pore with a ratio of Ti: O elemental composition of 1: 2. Voltammogram showed the anodes in 0.5 M NaOCl4 electrolyte in PC solvent has a good stability potential windows with the high current density 1.2 mA and the capacity of 0.037 F/g

Full Text:

Full Text PDF

References


H. Xiong, M. D. Slater, M. Balasubramanian, C. S. Johnson, and T. Rajh, “Amorphous TiO2 Nanotube Anode for Rechargeable Sodium Ion Batteries,” J. Physial Chem. Lett., vol. 2, pp. 2560–2565, 2011.

M. Okoshi, Y. Yamada, A. Yamada, and H. Nakai, “Theoretical Analysis on De-Solvation of Lithium , Sodium , and Magnesium Cations to Organic Electrolyte Solvents,” J. Electrochem. Soc., vol. 160, no. 11, pp. 2160–2165, 2013.

F. Sagane, T. Abe, and Z. Ogumi, “Sodium-ion transfer at the interface between ceramic and organic electrolytes,” J. Power Sources, vol. 195, no. 21, pp. 7466–7470, 2010.

D. Kundu, E. Talaie, V. Duffort, and L. F. Nazar, “The Emerging Chemistry of Sodium Ion Batteries for Electrochemical Energy Storage,” Angew. Chem. iIternational Ed., vol. 54, no. 11, pp. 2–20, 2015.

T. Perveen, M. Siddiq, N. Shahzad, R. Ihsan, A. Ahmad, and M. Imran, “Prospects in anode materials for sodium ion batteries - A review,” Renew. Sustain. Energy Rev., vol. 30, no. 40, p. 109549, 2019.

H. Xiong, M. D. Slater, M. Balasubramanian, C. S. Johnson, and T. Rajh, “Amorphous TiO2 Nanotube Anode for Rechargeable Sodium Ion Batteries,” J. Physial Chem. Lett., vol. 2, pp. 2560–2565, 2011.

M. Okoshi, Y. Yamada, A. Yamada, and H. Nakai, “Theoretical Analysis on De-Solvation of Lithium , Sodium , and Magnesium Cations to Organic Electrolyte Solvents,” J. Electrochem. Soc., vol. 160, no. 11, pp. 2160–2165, 2013.

F. Sagane, T. Abe, and Z. Ogumi, “Sodium-ion transfer at the interface between ceramic and organic electrolytes,” J. Power Sources, vol. 195, no. 21, pp. 7466–7470, 2010.

D. Kundu, E. Talaie, V. Duffort, and L. F. Nazar, “The Emerging Chemistry of Sodium Ion Batteries for Electrochemical Energy Storage,” Angew. Chem. iIternational Ed., vol. 54, no. 11, pp. 2–20, 2015.

T. Perveen, M. Siddiq, N. Shahzad, R. Ihsan, A. Ahmad, and M. Imran, “Prospects in anode materials for sodium ion batteries - A review,” Renew. Sustain. Energy Rev., vol. 30, no. 40, p. 109549, 2019.

F. R. Z. Ã and N. A. Ghalwa, “Removal of o -nitrophenol from water by electrochemical degradation using a lead oxide / titanium modified electrode,” vol. 86, pp. 291–296, 2008.

S. Guo, J. Yi, Y. Sun, and H. Zhou, “Recent Advances in Titanium-Based Electrode Materials for Stationary Sodium-Ion Batteries,” Energy Environ. Sciece, vol. 9, no. 10, pp. 2978–3006, 2016.

Y. Qiao, S. Bao, C. M. Li, X. Cui, Z. Lu, and J. Guo, “Nanostructured Polyaniline / Titanium Dioxide Composite Anode for Microbial Fuel Cells,” Am. Chem. Soc. NANO, vol. 2, no. 1, pp. 113–119, 2008.

Z. Tan, W. Zhang, Z. Zhang, D. Qian, and Y. Huang, “High-Performance Inverted Polymer Solar Cells with Solution-Processed Titanium Chelate as Electron-Collecting Layer on ITO Electrode,” Adv. Mater., vol. 24, pp. 1476–1481, 2012.

C. Wu, P. Wu, and P. Lin, “Evaluation on carbon nanocapsules for supercapacitors using a titanium cavity electrode,” J. Power Sources, vol. 195, no. 15, pp. 5122–5129, 2010.

H. Usui, K. Wasada, M. Shimizu, and H. Sakaguchi, “Nb-Doped Rutile TiO 2 : a Potential Anode Material for Na-Ion Battery,” Appl. Mater. Interfaces, vol. 7, pp. 6567–6573, 2015.

Z. Yang et al., “Nanostructures and lithium electrochemical reactivity of lithium titanites and titanium oxides : A review,” J. Power Sources, vol. 192, pp. 588–598, 2009.

L. T. Anh et al., “Improving the Electrochemical Performance of Anatase Titanium Oxide by Vanadium Doping as an Anode Material for Lithium-Ion Batteries,” J. Power Sources, pp. 1–30, 2013.

H. Wu, M. Hon, and C. Kuan, “Preparation of TiO2 ( B ) Nanosheets by a Hydrothermal Process and Their Application as an Anode for Lithium-Ion Batteries Preparation of TiO 2 ( B ) Nanosheets by a Hydrothermal Process and Their Application as an Anode for Lithium-Ion Batteries,” J. Electron. Mater., vol. 43, no. 4, pp. 1048–1054, 2014.

P. L. Díaz, M. C. Pereira, E. N. Codaro, and H. A. Acciari, “Structural Changes in TiO 2 Films Formed by Anodizing of Electro-Polished Titanium,” Mater. Sci. forum, vol. 869, pp. 689–692, 2016.

N. huda Yusoof, nur izzah abd Azes, N. Najmi, and M. ali Sulaiman, “Study on Liquid Electrolyte Using NaClO4 Salt for Low Cost Rechargeable Sodium-Ion Batteries,” J. Ind. Technol., pp. 12–18, 2017.

A. Ponrouch, E. Marchante, M. Courty, J. Tarascon, and M. R. Palac, “In search of an optimized electrolyte for Na-ion batteries,” Energy Environ. Sciece, vol. 5, no. 9, pp. 8572–8583, 2012.

A. Massoudi, A. Zamanian, and N. Khoshnood, “TiO2 Nanotube Arrays Fabricated by Electrochemical Anodization in Aqueous TiO 2 Nanotube Arrays Fabricated by Electrochemical Anodization in Aqueous Fluorine Media,” Interational Mater. Phys. J., vol. 2, no. 4, pp. 21–25, 2014.

D. Fang, K. Huang, S. Liu, and J. Huang, “Fabrication and Photoluminiscent Properties of Titanium Oxide Nanotube Arrays,” J. Braz. Chem. Soc., vol. 19, no. 6, pp. 1059–1064, 2008.

Z. Bi et al., “Self-organized amorphous TiO 2 nanotube arrays on porous Ti foam for rechargeable lithium and sodium ion batteries,” J. Power Sources, vol. 222, pp. 461–466, 2013.

A. R. Ainuddin and mohammad syazwan Sulaiman, “Effect of Anodizing Voltage and Annealing Temperature on the Growth of Titanium Dioxide Nanotube,” 2017.

S. Nam, S. Cho, and J. Boo, “Growth behavior of titanium dioxide thin films at different precursor temperatures,” Nanoscale Res. Lett., vol. 7, no. 89, pp. 1–6, 2012.

S. Ng, H. Sopha, R. Zazpe, Z. Spotz, and V. Bijalwan, “TiO2 ALD Coating of Amorphous TiO2 Nanotube Layers : Inhibition of the Structural and Morphological Changes Due to Water Annealing,” Front. Chem., vol. 7, no. 38, pp. 1–12, 2019.

V. Galstyan, E. Comini, G. Faglia, and G. Sberveglieri, “TiO2 Nanotubes: Recent Advances in Synthesis and Gas Sensing Properties,” Sensors, vol. 13, pp. 14813–14838, 2013.

A. El, R. Mohamed, S. Barghi, and S. Rohani, “N- and C-Modified TiO2 Nanotube Arrays : Enhanced Photoelectrochemical Properties and Effect of Nanotubes Length on Photoconversion Efficiency,” Nanomaterials, vol. 8, no. 198, pp. 1–16, 2018.




DOI: http://dx.doi.org/10.24845/ijfac.v6.i1.20

Refbacks

  • There are currently no refbacks.


 

Editorial Office:

Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Sriwijaya
Jl. Palembang-Prabumulih Km.35 Indralaya Ogan Ilir Sumatera Selatan 30662

 

 

Creative Commons License
IJFAC by Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Sriwijaya is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License